Disconnect device for jam tolerant linear actuator.. (FASTDISC)
Disconnect device for jam tolerant linear actuators
Start date: Feb 1, 2013,
End date: Jun 30, 2016
One target of actual development activities for helicopter drives is the substitution of the conventional swash plate actuation based on hydraulic actuators by electro-mechanical actuators. In comparison to hydraulic actuators the jam of the electro-mechanical actuators has to be considered by a jam tolerant system design.A possible solution is a redundant system configuration with two identical actuators at the activating positions. In case of a jam the failed actuator has to be disconnected from the drive in very short time by a fast activating actuator. In regard to the requirements no state-of-the art disconnect device is applicable.The development of the disconnect device shall cover two different principles:- reversible system, preferred electro-mechanical- “single-shot” system, preferred pyrotechnicalTherefore, the project work will be carried out by 4 cooperation partners:- The Institute of Engineering Design and Industrial Design of the University of Stuttgart (IKTD) has research experience in and expert knowledge on the development of fast operating connect/disconnect devices.- The Italian company Umbra (Umbra) is a highly competent manufacturer and supplier of components for the aerospace industry like ballscrews, actuators and EMA drives.- The German company PyroGlobe is a highly competent manufacturer and supplier of pyrotechnical components and will participate on the “single-shot” system.- The Swiss company phi Engineering has experience in methodical product development and will participate on a “single-shot” system beside pyrotechnics.During investigations performed by the IKTD a wide range of possible connect/disconnect principles were reviewed and concept studies were carried out in this context. This represents a promising basis for a continuative research work and a successful development may be expected.The experience of the industrial partners will ensure the realisation of the prototype considering the aerospace requirements.
Get Access to the 1st Network for European Cooperation