Search for European Projects

5 European Projects Found

Searched on 125080 European Projects

 FINISHED 

Cost Effective Reinforcement of Fastener Areas in Composites (CERFAC)

Start date: Oct 1, 2010, End date: Dec 31, 2014,

"CERFAC’s major challenge is the design and manufacturing of strong and cost-efficient joints for high performance CFRP aero-structures.In particular, transfer of distributed loading along rivets lines in the assembly of flat or curved thin-walled stiffened panels, and introduction of concentrated loads for connecting lugs with thicker laminates are special & frequent problems. Hence, CERFAC focus ...
Read Project

 15

 FINISHED 

Contribution to Analysis of Rotor Hub Drag Reduction (CARD)

Start date: Nov 1, 2010, End date: Oct 31, 2014,

"A major source of helicopter drag, about 30% of the total, is from the rotor hub. It is important that the drag generated by a helicopter, and hence emissions, is reduced. This research programme is to be undertaken to investigate this subject and investigate potential techniques to achieve reductions in hub drag. A wind tunnel test programme is to be carried out to provide a large, high-quali ...
Read Project

 3

 FINISHED 

Packaging of futuRe Integrated ModulAr Electronics (PRIMAE)

Start date: Nov 1, 2010, End date: Oct 31, 2014,

"Affordable transport for the citizen relies on innovative solutions and technologies that will result in lower costs and lead-time of the aircraft and its systems. In this area, the packaging of on-board computers is an important contributor.The Packaging of futuRe Integrated ModulAr Electronics (PRIMAE) objective is to develop a new flexible, robust and open aeronautical packaging for the next g ...
Read Project

 20

 FINISHED 

Innovative Manufacturing of complex Ti sheet components (INMA)

Start date: Sep 1, 2010, End date: Jun 30, 2014,

"The INMA project aims at developing an intelligent knowledge-based (KB) flexible manufacturing technology for titanium shaping that will lead to drastically reduce current aircraft development costs incurred by the fabrication of complex titanium sheet components with a minimal environmental impact. In particular, this project aims at strengthening European aircraft industry competitiveness, by t ...
Read Project

 11

 FINISHED 

Innovative Material Synergies & Composite Processing Strategies (IMS&CPS)

Start date: Oct 1, 2010, End date: Sep 30, 2013,

Mutation of transport industry to carbon fibre reinforced polymer (CFRC) is now ineluctable in order to reduce our mobility environmental imprint. This sector is at a turn of its conversion from metal to composite, which should impose a radical rethinking of the whole supply chain. Combined developments of materials and matched processes is the main strategy of IMS&CPS project, only such a concert ...
Read Project

 16